Figure 2.2 Flank Panel - American Dynamics illustra 400 Installation & Operation Manual

Installation and Operation Guide

Figure 2.2 Flank Panel:

1. IRIS: Auto iris connector.
This camera works with a DC drive auto iris lens. Please refer to the pin assignment
marked on the camera when connecting the auto iris lens
2. DIP Switch:
1.ALM-OUT A 7.RS-485:D+
2.ALM-OUT B 8.RS-485:D-
3.ALM-IN + 9.DC-OUT(5V)
4.ALM-IN - 10.GND
5.ALM-RST + 11.AUDIO-IN
6.ALM-RST - 12.AUDIO-OUT
1. AES: Auto electric shutter.
2. DC IRIS: Use an auto iris (DC drive)
3. DHCP: Turn On / Turn Off to use the DHCP protocol. If the switch
points upwards, the device can change the setup of
network function (enable/disable) via the network.
4. STATIC IP: If the switch points down, the device can't obtain an IP
(*In the default factory configuration, this DIP Switch is in the Down
position.)
IRIS
1
1. AES
2. DC IRIS
2
3. DHCP
4. STATIC IP
1
address from the DHCP server. This option is needed
to configure the network communication settings.
3
4
2
19