2.4 The Illustra 400 Bullet IP Camera Indoor/outdoor (PoE)
The component parts (the internal view).
Dismantle the bullet IP camera to see its different parts. The picture here shows you the internal
component items making up the product.
FRONT CASE
Camera with bracket (the external view).
The picture here shows the camera's exterior, with the bracket screwed in and fixed to it. The
bracket enables you to easily mount the camera on a wall, turned at the angle you want.
NOTE: Use the 2 screws to screw the sun shield
(above) into the 2 extreme holes indicated
in the bullet camera (below) to get an
unobstructed viewing angle.
Please don't use the middle hole in the
camera, as that will block the view.
22
SUN SHIELD
SD PCB
LENS FAN
POWER PCB
SENSOR PCB
PCB PLATE
IR PCB
Figure 2.5 The internal view of Bullet Camera
Figure 2.6 The external view of Bullet Camera
SCREWS
REAR CASE
MIDDLE CASE
WATERPROOF RUBBER
Installation and Operation Guide