State Transitions; Halt State - AMD K5 Technical Reference Manual

AMD-K5 Processor Technical Reference Manual
6.4.1

State Transitions

6.4.2

Halt State

6-34
tions can be entered from any of the processor's normal operat-
ing modes (Real, Virtual-8086, or Protected mode), from
system management mode (SMM), or from the Halt state.
In typical PC systems that implement power control, the STP-
CLK, CLK, and SMI signals are driven by external power man-
agement logic that monitors activity on the address and cycle-
definition signals. In a typical case, the power management
logic may notice that, after having initiated SMM to power
down one or more I/O devices, another several minutes have
elapsed without activity. Power management logic can again
assert SMI, the SMM service routine would obtain the relevant
information and decide to power itself (the processor) down,
and the decision would be communicated to the power man-
agement logic, which would assert STPCLK to the processor
and, optionally, stop driving CLK to the processor and other
logic. For details on SMI and STPCLK, see pages 5-116 and
5-122, respectively.
The five states in the processor's clock-control protocol, as
shown in Figure 6-6, are as follows:
Normal Execution: Real mode, Virtual-8086 mode, Protected
mode, or System Management Mode (SMM). In this state,
all clocks run at full speed.
Halt State
Stop Grant State
Stop Grant Inquire State
Stop Clock State
The sections below describe each of the four low-power states.
The processor enters the Halt state from the normal operating
modes (Real, Protected, or Virtual-8086) or SMM when it exe-
cutes the HLT instruction. The processor leaves the Halt state
and returns to its prior operating mode when RESET, SMI,
INIT, NMI, or INTR is asserted. If STPCLK is asserted within
the Halt state, the processor transitions to the Stop Grant
18524C/0—Nov1996
System Design