Njoy PWUP-OL300AT-AZ01B User Manual page 17

There are three parameters to set up the UPS.
•
Parameter 1:
below table.
•
Parameter 2-3:
program.
Interface
01: Output voltage settings
02: Frequency Converter enable/disable
03: Output frequency settings
For program alternatives. Refer to
The settings options or values for each
Settings
Parameter
following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac
(Default)
240: presents output voltage is 240Vac
Parameter
converter mode. You may choose
the following two options:
CF ENA: converter mode enable
CF DIS:
(Default)
Parameter
setting. You may set the initial
frequency on battery mode:
BAT 50:
is 50Hz
3: you may choose the
2&3: Enable or disable
converter mode disable
2&3: Output frequency
presents output frequency
17