Locations And Functions - JAI AT-200GE User Manual

4. Locations and Functions

4.1. Locations and Functions
1. Lens mount
2. CCD sensor
3. RJ-45 connector
4. 12-pin connector
5. D-sub 9-pin connector
6. LED
7. LINK
8. ACT
9.Holes for RJ-45 thumbscrews
10.Mounting holes
*1) Note: Applicable C-mount lens should be designed for 3-CCD cameras.
C-mount lens must be less than 4mm.
Be advised: when using a lens with the iris diaphragm fully open, vignetting on corners
may occur.
*2) Note: When an RJ-45 cable with thumb screws is connected to the camera, please do not
excessively tighten screws by using a driver. The RJ-45 receptacle on the camera might
be damaged. For security, the strength to tighten screws is less than 0.147 Newton
meter (Nm). Tightening by hand is sufficient in order to achieve this.
*3) Note: The tripod adapter plate MP-41 can be used.
AT-200GE
Lens mount of C-mount type. *1)
1/1.8 inch CCD
GigE Vision interface with thumb screws
DC+12V, Trigger IN and EEN out
LVDS IN and TTL IN and OUT
Power and trigger indications
Indication for Network connection
Indication for GigE communication
Vertical type and horizontal type (*2)
M3, max length 5mm (*3)
Fig. 1. Locations
- 8 -
Rear protrusion on