Routing The Wire; Rear U-Frame 1 - Ironman Fitness 5211 Owner's Manual

ROUTING THE WIRE

Route the wire as illustrated, place the Wire Holders (55) along the inner side of the frame
approximately 10 inches apart, all the way close to the bottom of frame. Lead the Power Cord (54)
through the protective cover all the way down. Use a Velcro Strap (58) to secure the Power Cord
(54) to the Pivot Arm (5). Attach the wire by pressing it into the holders. Slowly turn the table all
the way until it becomes 180 degree, to make sure the wire is long enough and will not entangle any
part of inversion table while you are using it.
Caution: Do not route the wire other than instructed herewith, or the wire may be snapped during
inverting.
Power Cord
Power Cord
Velcro Strap
18
Power Cord
Rear
U-Frame
Pivot Arm
Pivot Arm