Panasonic VQT1T63 Operating Instructions Manual page 29

u [VOLUME]
When you connect the camera to a TV, the volume of the TV speakers does not change.
•
[CUST. SET MEM.]
Refer to P83 for details.
•
[Fn BUTTON SET]
Refer to P51 for details about the review.
•
Refer to P103 for details about the
•
[MONITOR]
[LCD MODE]
LCD
The brightness of the pictures displayed on the LCD monitor is increased so some subjects
•
may appear differently from actuality on the LCD monitor. However, this does not affect the
recorded pictures.
The LCD monitor automatically returns to normal brightness after 30 seconds when recording
•
in Power LCD mode. Press any button to make the LCD monitor bright again.
If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or
•
another object to block the light.
The number of recordable pictures decreases in Auto Power LCD mode and Power LCD mode.
•
Preparation
Adjust the volume of the speaker to any of 7 levels.
Up to 4 current camera settings can be registered as custom
settings.
(Recording mode only)
Assign [REC] Mode Menu to 4 button. It is convenient to register
[REC] Mode Menu that is used often.
[REVIEW]/[FILM MODE]/[SENSITIVITY]/[WHITE BALANCE]/
[METERING MODE]/[AF MODE]/[I.EXPOSURE]
(Recording mode only)
[REC]
Mode Menu.
Adjust the brightness of the LCD monitor in 7 steps.
These menu settings make it easier to see the LCD monitor when
you are in bright places.
[OFF]
„ [AUTO POWER LCD]:
The brightness is adjusted automatically depending on how bright
it is around the camera.
... [POWER LCD]:
The LCD monitor becomes brighter and easier to see even when
taking pictures outdoors.
- 29 -