Note
If it fails to lock, AF area will flash in red, and disappear. Try to lock again.
•
AF Tracking will not operate when the subject is not specified, the subject is lost, or has failed
•
to be tracked. The picture will be taken with [
It is not possible to set [
•
scene mode, or in the motion picture mode.
[
] does not work in AF tracking.
•
The focus range becomes the same as AF macro mode. [1 cm (Wide)/30 cm (Tele) to ¶]
•
function may not work in the following cases:
•
Dynamic tracking
When the subject is too small
–
When the recording location is too dark or bright
–
When the subject is moving too fast
–
When the background has the same or similar colour to the subject.
–
When jitter is occurring
–
When using the zoom
–
∫ About AF area selection
You can select the AF area by pressing [FOCUS] when [
selected.
It is also possible to switch to AF area selection screen by pressing 1 when AF mode is
selected with 3/4.
You can set from the quick menu.
•
When selecting [ƒ], [Ø] or [Ù]
1
Press 3/4/2/1 to move the AF area.
You can set to arbitrary position of the screen.
•
(It cannot be set to edge of the screen)
After moving the AF area, press [DISPLAY] to
•
return it to the centre.
2
Press [MENU/SET] to set.
When selecting [
1
Press 3/4/2/1 to select AF area as
shown in the figure to the right.
2
Press [MENU/SET] to set.
Note
The spot metering target can also be moved to match the AF area when using [Ù] in
•
[METERING MODE].
Position of the AF area will return to initial state when the camera is set to Intelligent auto
•
mode, When the power save mode is activated, or When this unit is turned off.
Advanced (Recording pictures)
] in [STARRY SKY], [FIREWORKS], [PIN HOLE] or [FILM GRAIN] in
(P27)
]
M
] in [AF MODE] in that case.
Ø
M
- 116 -
], [ƒ], [Ø] or [Ù] is