Panasonic VQT1T63 Operating Instructions Manual page 174

Note
When the flash mode of the dedicated flash is set to [TTL AUTO], various different flash
•
settings can be selected to suit the recording mode. For the flash settings that can be selected,
refer to P59.
When the flash mode of the dedicated flash is set to [TTL AUTO] or [AUTO], the flash output
•
can be adjusted by the camera. For details, refer to the operating instructions of the dedicated
flash.
You can set the aperture value, the shutter speed and the ISO sensitivity on the camera even
•
when attaching the external flash.
Some commercial external flashes have synchro terminals with high-voltage or reversed
•
polarity. Using such extra flashes may cause a malfunction or the camera may not operate
normally.
If you use commercially available external flashes with communication functions other than the
•
dedicated one, they may not operate normally or they may be damaged. Do not use them.
Even if the external flash is turned off, the camera may enter the external flash mode when the
•
external flash is attached. When you are not using the external flash, detach it or set it to
Forced OFF.
When attaching the external flash, the built-in flash cannot be activated.
•
Do not open the built-in flash when an external flash is attached.
•
The camera will become unstable when attaching the external flash, it is recommended to use
•
a tripod when taking picture.
Turn off the camera when removing the external flash.
•
Detach the external flash when carrying the camera.
•
When attaching the external flash, do not hold only the external flash because it may detach
•
from the camera.
If you use the external flash when the white balance is set to [
•
balance depending on the picture quality.
If you take pictures close to the subject in Wide, the vignetting effect may appear on the bottom
•
of the recorded picture.
Read the operating instructions of the external flash for details.
•
Connecting to other equipment
(P111)
- 174 -
] finely adjust the white