Table of Contents
Advertisement
Aiming
On a typical UPC 100% hold the scanner between contact and 19 inches from the symbol (see
page
2-9). When scanning using a single-line scan mode, ensure the scan line crosses every bar and space of the
symbol.
012345
Acceptable and Incorrect Single-Line Aiming
Figure 2-3
When scanning using a multi-line scan mode, at least one scan line must cross every bar and space of the symbol.
012345
Acceptable and Incorrect Multi-Line Aiming
Figure 2-4
Regardless of the scan mode, the scan line is smaller when the scanner is closer to the symbol and larger when it
is farther from the symbol. Scan symbols with smaller bars or elements (mil size) closer to the scanner, and those
with larger bars or elements (mil size) farther from the scanner.
Do not hold the scanner directly over the bar code. Laser light reflecting directly back into the scanner from the bar
code is known as specular reflection. This specular reflection can make decoding difficult.
NOTE Scan line lengths vary depending on the scan line width selected. A full scan line width is the default.
Medium and short scan line widths are useful for scanning menus or pick-lists.
For more information about scan line widths and scanning modes, see
Pattern on page
4-6, respectively.
012345
012345
Scan Line Width on page 4-7
Scanning
2 - 5
Decode Zone on
and
Scan
Advertisement
Table of Contents
Troubleshooting
