Connecting Using Scanner Emulation - Motorola Symbol LS3008 Product Reference Manual

Hide thumbs Also See for Symbol LS3008:
Table of Contents

Advertisement

10 - 2 Symbol LS3008 Product Reference Guide

Connecting Using Scanner Emulation

To perform Scanner Emulation, connect the scanner to a mobile computer, or a controller which collects the data
and interprets it for the host.
Host Port
Connector
Scanner Emulation Connection
Figure 10-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the scanner remain
the same.
Attach the modular connector of the Scanner Emulation interface cable to the cable interface port on the
1.
scanner (see
Installing the Interface Cable on page
Connect the other end of the Scanner Emulation interface cable to the scanner port on the mobile computer or
2.
controller.
Scan the Scanner Emulation host bar code from
3.
Emulation host interface.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
4.
CAUTION
Connect the scanner to 5 volt decoders only. Connecting the scanner to a 12 volt decoder can
damage the scanner and invalidate the warranty.
Interface Cable
1-3).
Scanner Emulation Host on page 10-4
Figure 10-1
are examples
to enable the Scanner

Advertisement

Table of Contents
loading

Table of Contents