Air Flow And Air Filter - Akai MWF-18CRN1-QC1G Instruction Manual

Air flow and air filter

Vertical air flow adjustment (manually)
To adjust vertical air flow direction, adjust any one of the horizontal
louvre blades. When adjusting the horizontal louver blades up or
down, always keep the top or bottom blades horizontal. This can
effectively prevent water droplets condensing on the front panel
of the unit.
Air filter
The air filter behind the inlet grille should be checked and
cleaned at least once every 2 weeks (or as necessary) to
maintain optimal performance of the air conditioner. For
the units with " " (Clean Air) function, if symbol "E1"
displays in the LED window, switch off and disconnect the
air conditioner from the power supply and clean the filter
How to remove the air filter
1. The grille may be opened from the top or bottom for
easy maintenance after installation.
2. Open the inlet grille by pulling off the exposed door on
the bottom or top of the unit (based on installation).
3. Pull the tab slightly to release the filter. Pull the filter in
the same direction as the opening.
4. Clean the filter with warm, soapy water. The water
should be below 40 C to prevent distortion of the filter.
5. Rinse off and gently shake off excess water from the
filter. Allow the filter to dry before replacing it. To prevent distortion of the filter, do
not dry in direct sunlight.
Drainage
To meet different requirement of different type
of air conditioner, there are two kinds of methods
for your choice to treat the condensed water. You
can choose back drainage or non-drainage. See
the following procedures to perform back drainage:
1. Fit the seal onto the drain joint (which provided
with your air conditioner accessory).
2. Remove the rubber plug from the back of the unit.
3. Attach the drain joint to the back of the cabinet
where you remove the plug and rotate 90 to securely assemble them.
4. Connect the drain joint with a extension drain hose (Locally purchased).
After Sales Support 1300 886 649
DR AIN
JO INT
SE AL
20
RUBB ER
PLUG