Remote Control Operating Instructions; Replacing The Batteries - Akai MWF-18CRN1-QC1G Instruction Manual

Remote Control Operating Instructions

Location of the remote controller
Keep the remote controller where its signals can reach the
receiver of the unit (a distance of 8m is allowed). When you
select the timer operation, the remote controller automatically
transmits a signal to the indoor unit at the specified time. If you
keep the remote controller in a position that hinders proper
signal transmission, a time lag of up to 15 minutes may occur.
NOTE:
The air conditioner will not operate if curtains, doors or other materials block the
signals from the remote controller to the indoor unit. Prevent any liquid from falling
into the remote controller. Do not expose the remote controller to direct sunlight or
heat. If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the
air conditioner may not function properly. Use curtains to prevent the sunlight from
falling on the receiver. If other electrical appliances react to the remote controller.
either move these appliances or consult your local dealer.

Replacing the batteries

The remote controller uses two dry batteries (R03/LR03X2)
(1) Slide the cover of the battery compartment off according to the arrow direction,
then replace the old batteries with new ones.
(2) Insert the new batteries making sure that the(+) and (-) of battery are installed
correctly.
(3) Reattach the cover by sliding it back into position. After replacing batteries, set the
remote controller clock.
After Sales Support 1300 886 649
13