Setting The Clock - Akai MWF-18CRN1-QC1G Instruction Manual

Setting the clock

Before you start operating the air conditioner, set the clock of the
remote controller using the procedures given in this section. The
clock panel on the remote controller will display the time
regardless of whether the air conditioner is in use or not.
Initial Setting of the Clock
After batteries are inserted in the remote controller, the clock
panel will display "12:00". Press and hold the CLOCK button for
3 seconds, the time begin to flash.
1. TEMP/TIME adjust button
• Press this button to set time.
Forward.
Backward.
• Each time you press the button, the time moves forward or backward by one
minute depending on which side you press. The time alters as quickly as you push
the button.
• Keep pressing the button without releasing, the time moves forward or backward
by 10 minutes depending on which side you press.
2. CLOCK button
When the right time is achieved, press the CLOCK button or release the
wait for 5 seconds, the clock time stops flashing and the clock starts operating.
3. Readjusting the Clock
Press the CLOCK button on the remote controller for about 3 seconds, the clock
display time will start to flash. To set the new time, follow 1 and 2 of "Initial Setting
of the Clock".
Note:
The time of the CLOCK must be set before the AUTO-TIMER feature will
operate. If you readjust the time of the CLOCK after setting the AUTO-ON/OFF timer,
the remote controller will send the readjusted timer information to the unit.
* Clock accuracy is within 15 seconds per day.
Caution:
Static electricity or other factors (in case of extremely high voltage) can
cause remote controller clock initialize. If your remote controller is initialized
(flashing :00"), readjust the clock before "12 you start operation.
After Sales Support 1300 886 649
18
or and