Removing Icon Strips; Enabling Non-Projected Mode - SMART Notebook 10 User Manual

Hide thumbs Also See for Notebook 10:
Table of Contents

Advertisement

To remove icon strips
To enable
Non-Projected mode
12 2 |
CH A PT ER 19 – T H E S M A R T N O T E BO O K C O N T R O L P A N E L

Removing Icon Strips

If you set up a tool strip or custom icon strip, you can remove it at any time. After you
physically remove the strip, you must remove its properties in SMART Hardware
settings.
1. Open the SMART Notebook control panel.
2. Press SMART Hardware Settings.
The upper area of the control panel displays an image of the SMART product
connected to the computer.
3. If your computer is connected to more than one SMART product, the upper area
of the control panel displays an image of each SMART product. Press the image
of the product with the settings you want to change.
4. Select Set Up Icon Strips in the list.
5. Select the strip that you want to remove.
6. Press Remove.
7. Press OK to close the control panel

Enabling Non-Projected Mode

If you don't have a projector for your SMART Board interactive whiteboard, you can
use your SMART product in Non-Projected mode. You can write on the interactive
whiteboard in Non-Projected mode with dry-erase markers and save your notes in a
.notebook file.
CAUTION
Check your SMART product's installation guide for more information before
writing on it with dry-erase markers. For example, don't write on an interactive
screen if it has an OptiPro surface. OptiPro surfaces are optimized for use with
Projected mode.
1. Open the SMART Notebook control panel.
2. Press SMART Hardware Settings.
The upper area of the control panel displays an image of the SMART product
connected to the computer.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Notebook 10 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents