Element4 4 Installation, Operation And Owner's Manual page 91

FUNCTION
4.
Pilot lit.
Yes
5.
Sparking stops after
pilot is lit.
Yes
6.
Motor turns to main gas
and pilot stays lit.
Yes
7.
Main burner is lit.
Yes
8.
Main burner stays lit.
Yes
9.
Magnet unit drops while
motor turns. 3 beeps.
No
NORMAL OPERATION
Element4 Gas Fireplaces
APPENDIX THREE
TC- and SW-cable reversed.
No
Magnet unit not operating properly.
Short between interrupter and SW cable.
No gas (magnet unit drops after 30 second
audible count.)
Spark not lighting the pilot.
Short between interrupter and
TC-cable.
No
Electronic measuring amplifier defective.
No Resistance in thermocouple circuit too high.
Magnet
Not enough heat on thermocouple.
unit
drops
(audible
Low voltage from thermocouple.
sound)
No gas (magnet unit drops after 30 second
audible count.)
No Broken receiver
No
Ignition sequence stops.
No reaction to transmitter command.
No
Manual knob is in the "MAN" position.
Too much draft at pilot flame (poor
No
flame impingement of thermocouple.)
2 thermocouple is not heated.
nd
Receiver batteries low.
Yes
POSSIBLE CAUSE
91
REMEDY
Check cable connection between receiver
and interrupter block.
Replace gas valve.
Check interrupter block connection.
Check gas supply.
Check spark is crossing pilot orifice.
Check connection to interrupter block.
Replace the receiver.
Check thermocouple circuit.
Check position of pilot to thermocouple
and intensity of pilot flame.
Replace thermocouple. Do not over
tighten - hand tight + 1/4 turn maximum.
Check gas supply.
Ensure powered/unpowered receiver
allows manual operation.
Reset system.
Add ground wire between pilot burner
and gas valve.
Do not coil the ignition cable.
Shorten the ignition cable, if possible.
Turn the control knob to "ON" position (posi-
tive latch is required.)
Check installation.
Ensure 2 thermocouple is in the flame.
nd
Check 2 thermocouple wiring.
nd
Replace transmitter batteries. Quality 1.5V
AA alkaline recommended.
EuropeanHome.com