Laser On Time; Beep After Good Decode - Motorola Symbol LS9208 Product Reference Manual

Laser On Time

This parameter sets the maximum time that decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 10 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes from
Bar Codes that correspond to the desired on time. Include a leading zero for single digit numbers. For example, to
set an On Time of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error or
change a selection, scan Cancel on

Beep After Good Decode

Scan a bar code below to select whether or not the scanner beeps after a good decode. If you select Do Not Beep
After Good Decode, the beeper still operates during parameter menu scanning and indicates error conditions.
page D-4.
Laser On Time
*
Beep After Good Decode
(Enable)
Do Not Beep After Good Decode
(Disable)
User Preferences 4 - 7
Appendix D, Numeric