4-10
Symbol LS9203 Product Reference Guide
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan attempt. It is programmable in 0.1 second
increments from 0.5 to 10 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes beginning on page
D-1
in
D
that correspond to
the desired on time. Single digit numbers must have a leading zero. For example, to set an On Time of 0.5 seconds, scan the bar code
below, then scan the "0" and "5" bar codes. If an error is made, or to change a selection, scan Cancel on page D-8.
Laser On Time