Errors While Scanning; User Preferences Default Parameters - Motorola Symbol LS9208 Product Reference Manual

4 - 2 Symbol LS9208 Product Reference Guide

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences Default Parameters

Table 4-1 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar
code(s) provided in the User Preferences section beginning on
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
User Preferences
Set Default Parameter
Beeper Tone
Beeper Volume
Volume Change Trigger Delay
Laser On Time
Beep After Good Decode
Low Power Blink
Scan Pattern Mode
Single-Line Aim Duration
Time-out Between Same Symbol
Time-out Between Different Symbols
Time Delay to Low Power Mode
Linear UPC/EAN Decode
Appendix A, Standard Default Parameters
Parameter
page 4-3.
for all user preferences, hosts, symbologies, and
Default
All Defaults 4-3
High 4-4
High 4-5
5.0 Sec 4-6
3.0 Sec 4-7
Enable 4-7
Blink 4-8
Rastering 4-9
2 sec 4-10
0.6 sec 4-11
0.2 sec 4-11
30 Minutes 4-12
Disable 4-13
Page
Number