2 - 6
Symbol LS9208 Product Reference Guide
Standard Beeper Definitions (Continued)
Parameter Menu Scanning
Short high beep
Code 39 Buffering
3 long high beeps
4 short high beeps
Scanner gives a power-up beep
after scanning a USB Device Type.
This power-up beep occurs more
1 short high beep
ADF transmit error.
RS-232 receive error.
Correct entry scanned or correct menu sequence performed.
Input error, incorrect bar code or Cancel scanned, wrong entry,
incorrect bar code programming sequence; remain in program mode.
Keyboard parameter selected. Enter value using bar code keypad.
Successful program exit with change in the parameter setting.
Out of host parameter storage space. Scan
New Code 39 data was entered into the buffer.
Code 39 buffer is full.
The Code 39 buffer was erased or there was an attempt to clear or
transmit an empty buffer.
A successful transmission of buffered data.
Scanner has not completed initialization. Wait several seconds and
Communication with the bus must be established before the scanner
can operate at the highest power level.
The USB bus may put the scanner in a state where power to the
scanner is cycled on and off more than once. This is normal and usually
happens when the PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Set Default Parameter on