Laser On Time
This parameter sets the maximum time that decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes from
Bar Codes
that correspond to the desired on time. Include a leading zero for single digit numbers. For example, to
set a Laser On Time of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error
or change the selection, scan Cancel on
Laser On Time
Beep After Good Decode
Scan one of the following bar codes to select whether the scanner beeps after a good decode. If Do Not Beep
After Good Decode is selected, the beeper still operates during parameter menu scanning and indicates error
conditions.
*
Beep After Good Decode
(Enable)
page
D-3.
Do Not Beep After Good Decode
User Preferences
Appendix D, Numeric
(Disable)
5 - 7