Admin Account - Buffalo BSL-PS-G2108M User Manual

Chapter 2 Configuration
must also support the function for this to take effect.
• The Auto-MDI-X function is disabled if the rate and duplex mode are fixed.
• When using gigabit communications, autonegotiation must be used.
• SFP ports and shared ports can only be set to autonegotiation.
• When using trunk configuration, the mode is fixed to autonegotiation.
• When connecting to a device with a different rate that supports flow control, enable flow control
on the switch.
• QoS does not function while flow control is enabled.

Admin Account

These settings are used to configure the username and password used for logging in to the switch.
---> Basic > Admin Account
Parameter
Username
Password
Confirm Password
• The password field is displayed as being blank even when a password has been set. If you click
Apply in this condition, the password will no longer be set.
• When you click Apply, the username and password input screen will be displayed. Input the new
password.
• You may be unable to access the configuration interface if you forget the password.
• If the reset switch is enabled, you can restore the factory default settings by pressing the reset
button. The reset switch is enabled by default.
• If the reset switch is disabled, you must send the device to Buffalo Technical Support to restore the
factory defaults. In this event, please contact Buffalo Technical Support.
Meaning
The name of the Administrator account is "admin".
This is the password for logging in to the switch. It may contain up
to 8 alphanumeric characters, hyphens (-), and underscores(_).
Enter the password again.
- 19 -