English/Metric Default Setting Toggle - Life Fitness Lifecycle 9100R Operation Manual

19a04700.opm 6/30/00 10:08 AM Page 26
26
l

English/Metric Default Setting Toggle

The default setting of the Lifecycle 9100R aerobic trainer display console is set to
English units of measurements at the factory. If your display console will require
units of measurements to be in metric, it may be necessary to change the setting
from English to metric. To do so, you will need to enter into the diagnostic programs
and proceed to Diagnostic State 8. Follow the instructions as listed below.
Press and continue to hold the '5' key on the keypad and then press 'START' while
pedaling the bike over 55 RPM.
On entry, all LED's and 7-segment displays will be on. You are now in Diagnostic
State 1. Press the START/ENTER key seven times to forward to diagnostic state 8
and choose the default setting.
In ALL DIAGNOSTIC STATES, the user must keep pedaling the bike. If the pedal
RPM drops too low, the bike will shut down, requiring at least 40 RPM or greater
and a START switch closure to operate again.
Diagnostic State 8:
This test indicates the display console default setting of English or metric units of
measurements.
When the default is set to English units of measurements, it will read ' E ' in the
DATA ENTRY WINDOW.
When the default is set to metric units of measurement, it will read ' 9 ' in the DATA
ENTRY WINDOW.
The user can change the default setting of the system by pressing the ' 5 ' key. The
system will toggle from an ' E ' to ' 9 ' to ' E ' condition by continuing to press the ' 5 '
key.
Diagnostic State 7 can be entered now by pressing the CLEAR/PAUSE key and
you can continue going backwards by pressing the CLEAR/PAUSE key to previous
diagnostics until you return to the user display.