Fingerprint Reader Board - HP EliteBook 2170p Maintenance And Service Manual

Reverse this procedure to reassemble and install the hard drive.

Fingerprint reader board

Description
Fingerprint reader board (includes bracket and cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the hard drive (see
Remove the fingerprint reader board:
1. Release the zero insertion force (ZIF) connector to which the fingerprint reader board cable is
attached, and then disconnect the fingerprint reader board cable (1) from the SD Card
reader board.
2. Remove the Phillips PM2.0×2.0 screw (2) that secures the fingerprint reader board bracket to the
top cover.
Battery on page 56).
Service cover on page
Hard drive on page
58).
59).
Component replacement procedures
Spare part number
693349-001
61