Media Card Reader Assembly - HP EliteBook 2170p Maintenance And Service Manual

3. Remove the power switch board (2).
Reverse this procedure to install the power switch board.

Media Card reader assembly

NOTE: The Media Card reader assembly spare part kit does not include a Media Card reader
assembly cable. The Media Card reader assembly cable is included in the Cable Kit, spare part
number 693306-001.
Description
Media Card reader assembly
Before removing the Media Card reader assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. WLAN module (see
d. WWAN module (see
84 Chapter 4 Removal and replacement procedures
Battery on page 56), and then remove the following components:
Service cover on page
Hard drive on page 59)
WLAN module on page
WWAN module on page
58)
62)
64)
Spare part number
693353-001