Display Assembly Subcomponents - HP EliteBook 2170p Maintenance And Service Manual

Display assembly subcomponents

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
To access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. WWAN module (see
f. Fan (see
g. Keyboard (see
h. Base enclosure (see
i. System board (see
1. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Remove the display bezel screw covers (1).
The display bezel screw covers are available in the Rubber Kit, spare part number
693355-001.
b. Remove the two Phillips PM2.0×4.2 screws (2) that secure the display bezel and the display
clutch cover to the display assembly.
Battery on page
Service cover on page
Hard drive on page
Hard drive on page
WLAN module on page
WWAN module on page
Fan on page 68)
Keyboard on page
Base enclosure on page
System board on page
56), and then remove the following components:
58)
59)
59)
62)
64)
69)
76)
88)
Component replacement procedures
97