Table of Contents
Advertisement
a p p e n d i x d
E R R O R A N D I N F O R M AT I O N M E S S AG E S
Display read-out
LErr
... the lamp doesn't ignite within 2 minutes after having
Lamp error
received the 'Lamp ON' instruction from the controller.
Likely reasons are a missing or defective lamp, or
insufficient mains voltage. The lamp error will not
affect the performance of the PAL.
ErAb
...the A and B-section PCBs do not communicate cor-
A/B-section error
rectly with the receiver module.
ErrA
... the A-section PCB does not communicate correctly
A-section error
with the receiver module.
ErrB
... the B-section PCB does not communicate correctly
B-section error
with the receiver module.
ShEr
... the PAL "detects" that the lamp is ON but no 'Lamp
Short error
ON' command has been received. This can occur if
the lamp relays are stuck in the ON position or the
lamp-power feedback circuit has failed. You can still
use the PAL 1200 but may not be able to remotely
switch off the lamp.
Hot
... you attempt to ignite the lamp within 4 minutes after
Hot lamp
having switched it off. The PAL will store the "Lamp
ON" instruction and ignite the lamp once the 4 minute
period has expired.
TErr
...there is a failure in the time keeper circuit (internal
Time keeper error
clock). This error will not affect the performance or the
hour-counter for lamp and fixture usage.
34
Appears if...
PAL 1200, PAL 1200 E, PAL 1200 FX User Manual
What to do
• Check the lamp and check that the mains set-
ting of the fixture matches the mains supply.
• Check fuses on PCBs and that the ribbon cable
which connects the three PCBs is connected
properly.
• Check fuses on A-section PCB and the that rib-
bon cable which connects the three PCBs is
connected properly.
• Check fuses on B-section PCB and that the rib-
bon cable which connects the three PCBs is
connected properly.
• Contact your Martin dealer for assistance.
• Wait until the lamp strikes.
• Consult qualified Martin service personnel.
Hide quick links:
Advertisement
Table of Contents
