Rs-485 Settings; Hikvision Digital Technology Co., Ltd. All Rights Reserved - HIKVISION DS-2CD2132-I User Manual

User Manual of Network Camera
1. Enter RS-232 Port Setting interface:
Configuration> Advanced Configuration> System > RS232
Note: If you want to connect the camera by the RS-232 port, the parameters of the
RS-232 should be exactly the same with the parameters you configured here.
2. Click

10.8 RS-485 Settings

Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485
2. Set the RS-485 parameters and click
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and
the Parity and Flow Control is None.
Note: The Baud Rate, PTZ Protocol and PTZ Address parameters should be exactly
the same as the PTZ camera parameters.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Lo-Call 1890 866 900
RS-232 Settings
Figure 10-16
to save the settings.
RS-485 Settings
Figure 10-17
www.cctvireland.ie
to save the settings.
shop@cctvireland.ie
89