Email Sending Triggered By Alarm; Hikvision Digital Technology Co., Ltd. All Rights Reserved - HIKVISION DS-2CD2132-I User Manual

User Manual of Network Camera

6.6.6 Email Sending Triggered by Alarm

Purpose:
The system can be configured to send an Email notification to all designated
receivers if an alarm event is detected, e.g., motion detection event, video loss,
tamper-proof, etc.
Before you start:
Please configure the DNS Server settings under Basic Configuration > Network >
TCP/IP or Advanced Configuration > Network > TCP/IP before using the Email
function.
Steps:
1. Enter the
TCP/IP Settings (
Configuration > Advanced Configuration > Network > TCP/IP) to set the IPv4
Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred DNS Server.
Note: Please refer to Section 6.3.1 Configuring TCP/IP Settings for detailed
information.
2. Enter the Email Settings interface:
Configuration > Advanced Configuration > Events > Email
3. Configure the following settings:
Sender: The name of the email sender.
Sender's Address: The email address of the sender.
SMTP Server: The SMTP Server IP address or host name (e.g.,
smtp.263xmail.com).
SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25 (not secured).
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Lo-Call 1890 866 900
Configuration > Basic Configuration > Network > TCP/IP or
Email Settings
Figure 6-33
www.cctvireland.ie
62
shop@cctvireland.ie