Hikvision Digital Technology Co., Ltd. All Rights Reserved - HIKVISION DS-2CD2132-I User Manual

58
User Manual of Network Camera
You can configure the camera to trigger the alarm when the lens is covered and take
alarm response action.
Steps:
1. Enter the Tamper-proof Settings interface:
Configuration > Advanced Configuration > Events > Tamper-proof
Tamper-proof Alarm
Figure 6-28
2. Check Enable Tamper-proof checkbox to enable the tamper-proof detection.
3. Set the tamper-proof area; refer to Step 1 Set the Motion Detection Area in
Section 6.6.1.
4. Click to edit the arming schedule for tamper-proof. The arming
schedule configuration is the same as the setting of the arming schedule for motion
detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in Section
6.6.1.
5. Check the checkbox to select the linkage method taken for the tamper-proof.
Audible warning, notify surveillance center, send email and trigger alarm output are
selectable. Please refer to Step 3 Set the Alarm Actions for Motion Detection in
Section 6.6.1.
6. Click to save the settings.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Lo-Call 1890 866 900 www.cctvireland.ie shop@cctvireland.ie