Burner Tube Removal - Heat & Glo LUX36 Owner's Manual

I. Burner Tube Removal
• Disconnect power to appliance.
• Remove media from appliance.
• Remove the "L" plates and inner surround frame.
Note: Mark and note burner tube locations. They are not
interchangeable. See Figure 14.17.
Figure 14.17 Burner Tube Identifi cation
• Remove three cover plates by removing two screws
from each plate. See Figure 14.18.
Figure 14.18 Remove Three Plates
Heat & Glo • LUX36, LUX42 • 2287-900 • 2287-900 Rev. J
• Remove three outside burner tubes by removing two
screws on each tube. It will be necessary to remove
two screws from the pilot assembly and two screws
from the pilot shield on the rear burner tube prior to
removal. See Figure 14.19.
Figure 14.19 Remove Outside Burner Tubes
• Remove decorative steel log assembly by removing 3
screws, lifting up and out. See Figure 14.20.
Figure 14.20 Remove Decorative Steel Log Assembly
• Remove center burner tube by removing two screws.
See Figure 14.21.
Figure 14.21 Remove Center Burner Tube
• Adjust shutter settings as required.
• Reverse removal procedure to reinstall burner tubes
and log assembly.
Rev. J • 6/13
57