Table of Contents
Advertisement
D. Install Glass Refractory Panels
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
NOTICE: Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
Glass Panel Instructions
See-Through Models: See Section B
A. Single-Sided Models
1. Set back glass panel, labeled A in Figure 1, into firebox
on top of the two back glass spacer blocks, with the
smooth side of the glass facing outward. Position the
retaining bracket inside appliance as shown in Figure
3. Line up the hole in the heat shield with the hole
closest to the bend in the bracket and secure in place
with a screw. See Figure 2 and Figure 3.
2. Bend the hand bend on the bracket down 90 degrees.
See Figure 4.
3. Install side glass brackets by pushing up on the corner
of the top heat shield and use two self-tapping screws
to secure the bracket to the firebox. See Figure 5.
4. Install the left side panel, labelled "B" in Figure 1, by
sliding it into place from the front. While installing,
press the panel firmly against the firebox side.
5. Bend the tab on the glass bracket toward the side glass
panel until a 1/16 inch - 1/8 inch gap is created between
the tab and the side glass panel. See Figure 6.
6. Repeat for other side.
B. See-Through Models:
1. Set left side glass panel, labeled B in Figure 1, into
firebox with the smooth side facing outward.
2. Bend the hand bend on the bracket down 90 degrees.
See Figure 4.
3. Install side glass brackets using one self-tapping
screw to secure the bracket to the firebox. See Figure
7.
4. Bend the tab on the glass bracket toward the side glass
panel until a 1/16 inch - 1/8 inch gap is created between
the tab and the side glass panel. See Figure 6.
5. Figure 7 shows retaining bracket installed. Repeat for
other side.
Heat & Glo • MEZZO36-B/ST-B, MEZZO48-B/ST-B, MEZZO60-B/ST-B, MEZZO72-B/ST-B Installation Manual • 2300-973 Rev. R • 12/18
B
*Back panel used in single-sided models
Figure 1 Placement of Glass Panels
GLASS SPACER BLOCKS (2)
Figure 2 Glass Spacer Block Location - Back
Figure 3 Retaining Bracket Installation - Back
Figure 4 Retaining Bracket - Side Panel
A*
C
HAND BEND TAB
61
Advertisement
Table of Contents
