Installer Guide; Getting Started; Typical Appliance System - Heat & Glo LUX36 Owner's Manual

4 4

Getting Started

A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual.
Note: Dual venting configurations
ARE NOT allowed. Appliance MUST
be vented EITHER ver tically OR
horizontally.
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.D)
VENT PIPE (SECTIONS 7 and 8)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8.C )
FRAMING/HEADER
(SECTION 5)
GAS LINE
SECTION 11.C
Figure 4.1 Typical System

Installer Guide

VERTICAL TERMINATION CAP
(SECTION 10.F)
STORM COLLAR
(SECTION 10.E )
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 10.D)
ATTIC INSULATION SHIELD (NOT
SHOWN) MUST BE USED HERE TO
KEEP INSULATION AWAY FROM
VENT PIPE IF ATTIC IS INSULATED
(SECTION 8.D)
Heat & Glo • LUX36, LUX42 • 2287-900 • 2287-900 Rev. J
HORIZONTAL TERMINATION CAP
SECTION 10.H
FRAMING HEADED OFF
IN CEILING JOISTS
(SECTION 8.C )
MANTEL AND
MANTEL LEG
(SECTION 13.B )
OPTIONAL
WALL SWITCH
HEARTH EXTENSION
(SECTION 5.E)
Rev. J • 6/13
17