Battery Box Removal - Epson PhotoPC2100Z Service Manual

PhotoPC 2100Z

4.2.2.5 Battery Box Removal

1. Remove the housing. (See "Housing Disassembly" on page 50)
2. Remove the Power Supply Circuit Board. (See "Power Supply Circuit Board Removal"
on page 53)
3. Remove the Flash Circuit Board. (See "Flash Circuit Board Removal" on page 54)
4. Remove the Eject Button from the CF card slot using tweezers, and place the Eject
Lever on the lens side.
5. Remove the one screw (THB1.7x4.0) securing the copper foil and battery box.
NOTE: Tightening torque for the screw THB1.7x4.0: 0.12N⋅m
Copper foil
Figure 4-13. Copper Foil Securing Screws
Do not touch the copper foil with a bare hand. A surface of the
C A U T I O N
copper foil oxidized due to soiling could lower the capacity to resist
radiation noise.
Disassembly and Assembly
THB1.7x4.0
6. Remove the one screw (THB1.7x4.0) securing the Main Circuit Board and Battery
Box.
NOTE: Tightening torque for the screw THB1.7x4.0: 0.12N⋅m
Eject Button
Figure 4-14. Main Circuit Board / Battery Box Securing Screw
7. Disengage the pin of the Battery Box from the Main Circuit Board.
Disassembly
Revision B
THB1.7x4.0
Pin
56