Front Cover Removal - Epson PhotoPC2100Z Service Manual

PhotoPC 2100Z
W A R N I N G When the Rear Cover has been removed, the terminals of the
capacitor C3108 for flash firing appears at the upper left corner of
the camera. Be sure to discharge the capacitor using a cement
resistor. (Use a cement resistor with a resistance of about 500Ω to 1
kΩ/10W.)
Terminals
Cement resistor
Disassembly and Assembly

4.2.1.2 Front Cover Removal

1. Remove the Rear Cover. (See "Rear Cover Removal" on page 50)
2. Remove the three screws (THB1.7x4.0) securing the Front Cover.
NOTE: Tightening torque for the screw THB1.7x4.0: 0.12N⋅m
Figure 4-4. Front Cover Securing Screws
3. Remove the Front Cover. At this point, the card door comes off together.
Before installing the Front Cover, clean the inside of the lens
C H E C K
P O I N T cover with a blower.
Disassembly
THB1.7x4.0 Card Door
THB1.7x4.0
Revision B
51