Tools; Adjustment Programs - Epson PhotoPC2100Z Service Manual

PhotoPC 2100Z

5.2 Tools

5.2.1 Tools
The table below lists the tools needed for adjustments of PhotoPC 2100Z.
Table 5-2. Adjusting Tools
Adjustment Items
BC adjustment
LCD adjustment
LCD adjustment / USB ID writing
CCD gain adjustment, shutter
compensation and black defect input
& white defective compensation
Strobo adjustment
AF adjustment

5.2.2 Adjustment Programs

The adjustment items require the respective adjustment programs. For use, register
adjustment programs in CF cards, respectively.
Table below shows the adjustment items and files.
Table 5-3. Adjustment Programs
Adjustment Item
"BC (Battery Check) Compensation Value Writing"
"LCD (Brightness) Adjustment"
"CCD Gain Adjustment, Shutter Compensation Black
Defect Writing and White defect compensation",
"Strobo Adjustment"
"AF (Auto Focus) Compensation"
"USB ID Writing"
Adjustment
Tool Tool Code
Battery Tool 1091789
RS-232C I/F 1091792
RS-232C cable 1091790
cable
Color viewer 1030584
Strobo adjust chart 1091791
AF adjustment chart Attached at the end of
this manual
File Name
BC.c21
1. CRT21ma.exe
2. LCD.c21
CCD.c21
Strobe.c21
AF.c21
1. CRT21sp.exe
2. USB.c21
The PC to be used must be of a model which permits use of the
C A U T I O N
USB interface on Windows 98 or a later operating system.
Only one program file must be stored in one CF card if the file
name has an extension "c21". If two or more program files with
an extension "c21" are stored in one CF card, proper selection
of the program to be executed by the camera will not be
ensured.
When storing a program in a CF card, pay attention to the
property of the file. If the property is "read only", the camera
can not execute the program. And, check a mark on the archive
check box in the property, otherwise the camera can not
execute it too.
When all the adjustments to be made, perform "BC (Battery
Check) Compensation Values Writing" first. The other
adjustments can be performed in any sequence. These
adjustments include the initialization of the adjusted value
storage area in the camera.
Once "BC (Battery Check) Compensation Values Writing" is
performed, be sure to perform all the other adjustments
subsequently, without omitting any of them.
Once any error occurs during execution of an adjustment,
perform the same adjustment again under the same conditions.
(See "Explanation of Error Codes" on page 62)
If an error recurs, check for proper conditions under which the
adjustment is performed.
When performing any of the CCD adjustment, AF adjustment
and Strobo adjust, make sure that the lens cover is open.
Tools
Revision E
61