Power Supply Circuit Board Removal; Monitor Lcd Removal - Epson PhotoPC2100Z Service Manual

PhotoPC 2100Z

4.2.2.2 Power Supply Circuit Board Removal

1. Remove the housing. (See "Housing Disassembly" on page 50)
2. Remove the one screw (THB1.7x2.5) and the one screw (SPB1.7x4.0) securing the
Power Supply Circuit Board.
NOTE: Tightening torque for the screws SPB 1.7x2.5 and THB1.7x4.0: 0.12N⋅m
SPB 1.7x2.5
Figure 4-7. Power Supply Circuit Board Securing Screws
3. Remove the Power Supply Circuit Board downward.
C H E C K
When installing the Power Supply Circuit Board in the battery
P O I N T
box, make sure that the connector of the battery box and the
terminal of the circuit board are connected correctly, without
floating from each other.
Disassembly and Assembly

4.2.2.3 Monitor LCD Removal

1. Remove the housing. (See "Housing Disassembly" on page 50)
2. Remove the Power Supply Circuit Board. (See "Power Supply Circuit Board Removal"
on page 53)
3. Disconnect the harness for the backlight from the connector CN3104 on the Flash
Circuit Board.
THB1.7x4.0
4. Remove the one screw (SPB1.7x4.0) securing the Monitor Fixing Frame.
NOTE: Tightening torque for the screw SPB 1.7x2.5: 0.12N⋅m
Main Circuit Board
Disassembly
Figure 4-8. Connector CN3104
SPB1.7x4.0
Hook
CN1105,1106
Figure 4-9. Monitor Fixing Frame Securing Screws
Revision B
CN3104
Upper hook
Gasket
Hook
53