Removal Of Sy1 Board And Holder Battery - Epson PhotoPC 850Z Service Manual

EPSON PhotoPC 850Z

4.2.2 Removal of SY1 Board and Holder Battery

This section describes how to remove the SY1 Board and Holder Battery. Be
sure to follow the number shown in the figure below.
Disassembly and Assembly
7. Two
screw 1.7 x 5 (B)
16. Connector
8. Two screws
1.7 x 5 (B)
9. Two
screw 1.7 x 5 (B)
10. Holder
grip
9. Holder battery
Figure 4-4. Removal of SY1 Board and Holder Battery
If you removed the Lens VF, make sure to adjust the
position of gears when assembling the camera (see 4.3.2
"Installing Lens VF").
3. Connector
1. Two screws 1.7 x 4
6. Two screws
1.7 x 4
2. FPC
11. Five screws
1.7 x 4
Diassembly and Assembly
4. SY1 board
5. Connector
13. Two screws
1.7 x 4 (B)
14. Lens VF
12. Holder chassis B
Revision A
67