Overview; Check Items Before Shipment - Epson PhotoPC2100Z Service Manual

PhotoPC 2100Z

6.1 Overview

PhotoPC 2100Z requires no specific maintenance (lubrication / adhesion / cleaning).
Camera should be cleaned according to its necessity, however, such as for dust
incoming at the repairing service or fingerprint. The following table lists the check
items before sending the camera back to users

6.1.1 Check Items before Shipment

Check the camera according to Table 6-2. If you find any dust or dirt on the camera,
clean it referring to Chapter 4 "Disassembly and Assembly". Clean the camera of dust
and fingerprints by the method as described in Table 6-1 below.
Table 6-1. Places to be Cleaned and Cleaning Method
Places to be Cleaned
Exterior casing • Wipe with a soft dry cloth.
• If the dirt is heavy, first remove it with a soft cloth which has
been dipped in a neutral detergent diluted with water and then
squeezed up. After that, wipe with a soft dry cloth.
Lens Blow the dust off by a blower or an air blush. Then gently wipe
with a soft cloth.
Monitor LCD Gently wipe with a soft dry cloth.
Flash window Gently wipe with a soft dry cloth.
Self-timer window Gently wipe with a soft dry cloth.
Pay special attention to dirt or scratches on the flash window,
C A U T I O N
which can cause the flash window to be deformed.
Remember that dirt or scratches on the flash window can also
cause abnormal flash firing.
Maintenance
Cleaning Method
Table 6-2. Check Items before Shipment
No.
1 What is firmware version? Ver.
2 Are the inside and outside of the lens viewer free from
fingerprints or any other soiling.
3 Are the inside and outside of the flash window free from
dust or foreign matter adhesion?
4 Is the lens surface free from fingerprints or dust?
5 Are the inside and outside of the Monitor LCD window
free from fingerprints or dust?
6 Has the Battery Cover been installed in the Rear Cover
properly and does it open and close normally, with a click
felt?
7 Does the camera ensure normal insertion of the
CompactFlash card?
8 Has the Connector Cover been installed in the Rear Cover
properly and does it open and close normally, with a click
felt?
9 Do all the switch buttons operate properly?
10 Is the appearance clean?
11 Have all the accessories installed in position or packed
together for delivery, without forgetting any of them?
Overview
Check Item
Revision B
OK/NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
73