Table of Contents
Advertisement
PhotoPC 2100Z
If a printed chart is to be used, make sure that the pattern of
C A U T I O N
the chart is not incomplete, soiled or blur.
Slant the chart about 25 degrees so that the vertical stripes of
the pattern are never in the upright position.
Center of the lens
Since the allowable ambient illumination at the chart surface is
about 300 to 1000 luces, the general ambient illumination
conditions are acceptable. However, take care that too
intensive light does not hit the chart.
Adjustment Procedure
1.
Open the lens cover of the camera.
2.
Connect the AC adapter to the camera.
3.
Insert into the camera the CF card in which the AF adjustment program has been
installed.
4.
Place the camera at a position where the distance from the chart to the lens surface with
the lens on the WIDE side is 70 cm.
5.
Hold down the F Button and Shutter Button together and press the Playback Button.
6.
Upon completion of preparation, press the Shutter Button fully. Adjustment will be
started
7.
At completion of adjustment, "OK" is displayed on the monitor of the camera.
Adjustment
8.
9.
10. Disconnect the AC adapter from the camera.
AF Adjustment Chart
About 25 degrees
Adjustment
Press the Shutter Button fully to turn off power to the camera.
Remove the CF card from the camera.
Do not move the camera during adjustment.
C A U T I O N
Revision E
70
Advertisement
Table of Contents
