Table of Contents
Advertisement
26
Steps for Finalizing the Installation
1. Remove the glass (see page 25).
NOTE:
If using propane (LP) convert the appliance prior to installing the media.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Install the four AA batteries (see illustration below). The AA batteries act as a power backup in case
the household (AC) power goes out and are required for operation.
the remote (see illustration below). Synchronize the transmitter to the IFC (see page 32).
4. Make sure the accent light bulbs are in place and work correctly.
NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
5. Replace the glass.
6. Start the heater.
7. Leak test all gas joints.
8. Adjust the air shutter following the directions on page 30.
9. Attach the face following the directions included with the face.
10. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame
on low position. The flames should burn off of each burner hole. If the heater does not work correctly,
contact your Travis dealer for a remedy.
11. Give this manual to the homeowner for future reference and fully explain operation of this heater.
© Travis Industries
Finalizing the Installation
4140811
Install three AAA batteries into
100-01331
Advertisement
Table of Contents
