Table of Contents
Advertisement
Optional Equipment (for qualified installers only)
6. Install the LP pilot orifice following the directions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then
replace the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
7. Replace the firebox components. Restore the fireplace to the correct configuration. Install the
firebacks before re-installing the burner.
8. Access the stepper motor (shown below). The stepper motor (adjustable regulator) has an
installation sheet included with it – make sure to follow all of the directions.
9. Disconnect the wiring from the stepper motor.
10. Remove the stock stepper motor and replace with the LP version. – MAKE SURE IT IS
CORRECTLY ORIENTED.
11. Secure using the screws included with the motor – tighten to 25 Lb-inches. Leak test this area after
installation to verify proper installation.
12. Re-attach the wiring.
13. Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line
(if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
© Travis Industries
Natural Gas Orifice = .020N (3way)
.018N (2way)
LP (Propane) Orifce = .014LP
7/16" Wrench
4140811
b
.020N
or
.018N
.014LP
51
100-01331
Advertisement
Table of Contents
