Laser Setup - pro.point 8439630 User Manual

V 2.7
5. Set up the outer flange on
the spindle of the blade by
using the hex wrench to
lock the shaft screw (B).
Push the safety lever (A)
to lock the shaft screw and
fix the blade in place. See
figure 5.
Note: Blade should not
shake after it is fixed in
place. There also should not
be a gap between the blade
and flange.
TO MAKE A BEVEL CUT
Loosen the handle (A), move the
base along the angle plate from
0° to 45° (or the degree that you
want), then tighten the handle.
See Figure 6.

LASER SETUP

1. Connect the plug into a
power source outlet and
turn on the laser switch
(A). The laser will emit a
guideline for cutting (B).
See Figure 7.
2. The laser's position is
12
7-1/4 in. Metal Cutting Circular Saw
For technical questions call 1-800-665-8685
8439630
Fig.5
Fig.6
Fig.7