Viper 5301 Installation Manual page 39

Step
1 Auto Learn Standard Configuration (default)
The auto learn configuration will automatically setup the remote
button configuration. Note: Due to the Supercode protocol, you
cannot change the configuration.
2 Delete remotes: This feature will erase all remotes from the memory
of the system. This is useful in cases when a customer's remote is
lost or stolen. Note: Does not reset the programmed features of the
system or reset the Virtual Tach setting.
3 Reset Features: This resets all the features of the system to the fac-
tory default settings. Note: Does not delete the remotes from the
system or reset the Virtual Tach setting.
4 Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization.Note: The "Zap" feature on the Bitwriter
does not reset the Virtual tach setting.
Learn Routine is exited if:
• The ignition is turned off
• The program switch is pressed too many times
• More than 30 seconds elapses between steps
© 2008 Directed Electronics. All rights reserved.
4.Transmit. While holding the Valet/Program switch,
press the button on the remote control. The horn
honks to confirm that the code has been success-
fully programmed. It is not possible to teach a re-
mote control button to the system more than once.
5. Release. Once the code is learned, the Valet/Program
switch can be released. You can advance from one func-
tion step to another by releasing the Valet/Program switch
and tapping it to advance function steps and then holding
it.
Function
39