Viper 5301 Installation Manual page 55

3-8 Flex Relay Function:
Ignition 2 (1) In the factory setting, the flex relay will
function the same as the pink ignition 1 wire, in accessory setting the flex relay
will function the same as the Orange accessory 1 wire, in starter setting the flex
relay will function the same as the purple starter 1 wire.
3-9 Diesel Timer—Wait-To-Start Input
- Timed 15, 30, 45 SECONDS:
Default is the "Wait-to-Start" input control wire, or programmable to ignore the
input control wire by a delay of 15 (2), 30 (3), or 45(4) seconds. This feature
can also be optionally programmed with the Bitwriter®, with a delay from 1 to
90 seconds.
3-10 Accessory State During Wait-To-Start On:
This feature will allow the se-
lection of the accessory output to be ON or OFF during wait-to-start. Use the
two-honk setting for OFF.
3-11 2nd Status Output: Normal:
This feature will allow selection of status
output or a rear defogger mode that turns on ten seconds after the vehicle has
started if the vehicle interior temperature is below 55 degrees F. The defogger
mode has two selections, latched, the LED will flash twice, or pulsed, the LED will
flash three times. Latched mode will only stay on for 10 minutes.
Note: When the defogger mode is on, the output will always be active and can
be turned on independently with the remote for a one-time activation. (See the
Remote Functions table.)
3-12 Parking Lights Constant:
In the default setting, the parking lights (if con-
nected) will come on solid during the remote start runtime. In the two- flash setting
the parking lights will flash during the remote start runtime. In the OFF setting, the
parking lights will not come ON or flash, when the vehicle is remote started.
3-13 Anti-Grind On:
With the anti-grind On (default) the ground-when-armed
output will be active during remote start operation. This activates the optional
starter kill relay and prevents the customer from re-cranking the car with the key,
when doing key takeover. If accessories such as a voice module or window
module are added to the unit, it may be necessary to use the two-honk setting
to program this feature OFF.
55
© 2008 Directed Electronics. All rights reserved.