Table of Contents
Advertisement
H1/3
BROWN
This wire supplies a (-) 200 mA output that can be used to honk the vehicle horn.
It outputs a single pulse when locking the doors with the remote, and two pulses
when unlocking with the remote. This wire also outputs pulses for 30 seconds
when Panic Mode is activated. If the vehicle has a (+) horn circuit, an optional
relay can be used to interface with the system.
H1/4
WHITE/BROWN
This wire connects to pin 87a of the onboard light flash relay. It is used when-
ever light switch isolation on the vehicle is necessary. If the vehicle has a mul-
tiplex circuit that needs the light switch isolated, you can remove the onboard
light flash fuse and replace it with the specified resistor (paying attention to the
polarity selection).
Multiplex
wire in car
To control
module in car
16
(-) HORN OUTPUT
LIGHT FLASH -ISOLATION WIRE - PIN 87a of onboard relay
Multiplex Lightflash Interface
Lightswitch
White/Brown
White
Replace fuse with
specified resistor value
Light Flash Fuse
Jumper under door
© 2008 Directed Electronics. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
