Bosch 2600 Series Instruction Manual page 25

LTC 2600 Series | Instruction Manual | Multiplexer Set (MS) Commands
MS-VCR-RELAY <vcr> <responds to> <polarity>
This command sets the response and polarity for the
relay connected to the VCR attached to the specified
monitor.
Parameter values for <vcr >, <responds to>, and
<polarity> are as follows:
<vcr> 1
2
<responds to> 0
1
2
3
<polarity> 0
1
MS-VCR-TEST <boolean>
This command turns ON/OFF the VCR test mode. If
ON, monitor A goes to full screen, and the data being
received from the VCR is displayed on monitor A.
Parameter values are <0> for OFF, <1> for ON.
MS-VCR-TIMELAPSE <vcr> <timelapse-mode>
<vcr-mode>
This command sets the timelapse mode for the VCR
attached to the <vcr>...
NOTE to NHU-this description in the new CCL
document is very confusing -- can we rewrite it?
Parameter values for <vcr >, <timelapse-mode>, and
<vcr-mode> are as follows:
<vcr> 1
2
<timelapse-mode>1
2
<vcr-mode> 1 to 20
MS-VCR-TITLE <custom-vcr-model#> <text >
This command assigns a title to the custom VCR
definition designated by <custom-vcr-model#>.
Bosch Security Systems | July 12, 2004
VCR output
VCR/Monitor B output
Neither
Action
Alarm
Both
Normally open
Normally closed
VCR output
VCR/Monitor B output
Normal
Action/Alarm
Parameter values are as follows:
<custom-vcr-model#>
<text>
MS-VCR-VEXT <vcr>
This command enables or disables VEXT input for the
VCR.
Parameter values for <vcr > and <boolean> are as
follows:
<vcr> 1
2
<boolean> 0
1
MS-VIDEOLOSS-OUT <polarity>
This command sets the output polarity for the VCR's
videoloss relay.
Parameter values for <polarity> are:
0
1
MS-VIDEOLOSS-OUT-ENABLE <boolean>
This command enables or disables the videoloss relay
output.
Parameter values for <boolean> are:
0
1
EN | 25
1 to 6 (corresponding to
custom VCR setting 1 to 6)
(Use acceptable
alpha/numeric characters-see
Appendix A; only the first 12
characters of <text> will be
used.)
VCR output
VCR/Monitor B output
Disables VEXT
Enables VEXT
Normally open
Normally closed
Disables videoloss relay
output
Enables videoloss relay
output