Bosch 2600 Series Instruction Manual page 33

LTC 2600 Series | Instruction Manual | Multiplexer Read (MR) Commands
MR-OPERATION-DUPLEX
This command returns the operating modes for duplex
multiplexer models.
Returned parameter values are:
<mode-D1> 1
2
3
<mode-D2> 0
1
MR-PASSWORD
This command returns the multiplexer password.
Returned parameter values for <password> are
<digit><digit><digit><digit> where <digit> equals
any number between 0 and 9.
MR-SEQ-DWELL <monitor> <mon-mode>
This command returns the sequence dwell time for the
specified monitor in the specified display mode.
Parameter values are:
<monitor> 1
2
<mon-mode> 1
2
<dwell-time> 0
(returned value) 1-60
MR-SEQ-DWELL-TIME <seq-device>
This command returns the sequence dwell time for the
specified monitor in the specified display mode (<seq-
device>).
Parameter values are:
<seq-device> 1
2
3
4
<dwell-time> 0
(returned value) 1-60
Bosch Security Systems | July 12, 2004
Monitor A - live digital
Monitor A - playback
Record ON - System4
models only
Record OFF
Record ON
Monitor A
Monitor B
Full screen mode
Quad mode
Sequence disabled
Dwell time in seconds
Monitor A - Full screen
Monitor A - Quad
Monitor B - Full screen
Monitor B - Quad
Sequence disabled
Dwell time in seconds
MR-SEQ-ENABLE <monitor>
This command returns the setting (enabled/disabled
sequencing) for the specified monitor if its display
mode is Full or Quad.
Parameter values are:
<monitor> 1
2
<boolean> 0
(returned value) 1
MR-SEQ-LIST <monitor> <display-mode>
This command returns the camera list being sequenced
in the specified mode on the specified monitor.
Parameter values are:
<monitor> 1
2
<display-mode> 0
1
2
3
4
5
6
<camera list>
(returned value)
EN | 33
Monitor A
Monitor B
Disabled sequencing
Enabled sequencing
Monitor A
Monitor B
Full screen
Single quad
3x3 multi
4+3 multi
12+1 multi
4x4 multi
8+2 multi
A list of camera numbers
(1-32) given in the order
desired for the
sequence/display