Table of Contents
Advertisement
LTC 2600 Series | Instruction Manual | General Commands
HEX
This command selects hexadecimal entry of numeric
values. In ASCII mode, this only affects input; output
is always in decimal, compatible with TC82XXC. In
binary mode, the radix applies to input and output.
LATCH-AUX-OFF <logical cam#> <auxiliary#>
This command unlatches the specified auxiliary
function/position on the specified receiver/driver
(<logical cam#>).
Parameter values are:
<logical cam#>
<auxiliary#>
EXAMPLE: If auxiliary number 5 is to be "unlatched"
on receiver/driver number 8, enter the following
command: LTC 2600> LATCH-AUX-OFF 8 5
NOTE: This command is useful for making level type
adjustments on the AutoDome Series cameras. Note
that no action will result if the remote device being
controlled does not support the auxiliary# value sent.
LATCH-AUX-ON <logical cam#> <auxiliary#>
This command latches the specified auxiliary
function/position on the specified receiver/driver
(<logical cam#>).
Parameter values are:
<logical cam#>
<auxiliary#>
EXAMPLE: If auxiliary number 5 is to be "latched" on
receiver/driver number 8, enter the following
command: LTC 2600> LATCH-AUX-ON 8 5
NOTE: This command is useful for making level type
adjustments on the AutoDome Series cameras. Note
that no action will result if the remote device being
controlled does not support the auxiliary# value sent.
Bosch Security Systems | July 12, 2004
1 to 999 (maximum number
of cameras)
1 to 7
1 to 999 (maximum number
of cameras)
1 to 7
PREPOS <logical cam#> <pre-position#>
This command sends the specified camera to the
specified pre-position.
Parameter values are:
<logical cam#>
<pre-position#>
EXAMPLE: If camera number 50 is to be sent to pre-
position number 8, then enter the following command:
LTC 2600> PREPOS 50 8
NOTE: The range of valid pre-position numbers is
from 1 to 16 for camera sites equipped with TC8561
Series receiver/drivers and from 1 to 99 for camera
sites containing the newer TC8561A Series
receiver/drivers. The AutoDome series of dome
cameras will respond to either 66 or 99 pre-positions
depending on the age of the model. Higher pre-
position numbers (above 100) are also used to activate
certain programming functions in the AutoDome
series, but currently these are not supported in the
TC8500 Series.
PREPOS-SET <camera#> <pre-position#>
This command sets the specified camera number's
current position as the specified pre-position number.
Parameter values are:
<camera#>
<pre-position#>
EXAMPLE: If camera number10 is to be programmed
for pre-position number 25, move the camera into the
desired pan/tilt/zoom position, then enter the following
command: LTC 2600> PREPOS-SET 10 25
NOTE: The range of valid pre-position numbers is
from 1 to 16 for camera sites equipped with TC8561
Series receiver/drivers and from 1 to 99 for camera
sites containing the newer TC8561A Series
receiver/drivers. The AutoDome series of dome
cameras will respond to either 66 or 99 pre-positions
depending on the age of the model. Higher pre-
position numbers (above 100) are also used to activate
certain programming functions in the AutoDome
series, but currently these are not supported in the
TC8500 Series.
EN | 40
1 to 999 (maximum number
of cameras)
1 to 99
1 to 16
1 to 99
Advertisement
Table of Contents
