Bosch 2600 Series Instruction Manual page 30

LTC 2600 Series | Instruction Manual | Multiplexer Read (MR) Commands
MR-CAM-AUTOCOLOR
This command returns the setting for the multiplexer
autocolor operation.
Parameter values for <auto-detect> are:
0
1
MR-CAM-COLOR
This command returns a 16-bit table value indicating
the settings for color operation of the cameras
connected to the system.
The <table 16> parameter ranges in value from <0> to
<65535> (decimal) OR <0> to <FFFF> (hex) where
the value in each table position corresponds to the
color operation of a specific camera (i.e. a value of 1
indicates enabled color; a value of 0 is disabled color
operation).
MR-CAM-FULL <monitor>
This command returns the camera number (displayed
in full screen) assigned to the specified monitor.
NOTE: If the monitor is not in full screen mode, the
command has no effect.
Parameter values for <monitor> and <camera#> are:
<monitor> 1
2
<camera#> 1 to 16
MR-CAM-NUMBER
This command returns the starting camera number to
be displayed on the monitor when the camera
connected to rear panel camera input #1 is selected.
Parameter values for <starting-number> range from
<1> to <983>.
MR-CAM-TITLE <camera#>
This command returns the camera title for the
specified camera number.
Parameter values for <camera#>:
<camera#> 1 to 16
Bosch Security Systems | July 12, 2004
Disables Autocolor
Enables Autocolor
Monitor A
Monitor B
MR-CAM-VIDEOLOSS-MESS <table 16>
This command returns a 16-bit table value for the
videoloss message status of individual cameras.
The <table 16> parameter ranges in value from <0> to
<65535> (decimal) OR <0> to <FFFF> (hex) where
the value in each table position corresponds to the
video loss message status of a specific camera (i.e. a
value of 1 indicates enabled video loss messages; a
value of 0 is disabled video loss messages).
MR-DISPLAY-MODE <monitor>
This command returns the display mode for the
specified monitor.
Parameter values for <monitor> and <display-mode>
are:
<monitor> 1
2
<display-mode> 0
1
7
8
9
10
11
NOTE: This command also returns a <screen-
number> value which for quad modes represents the
quad mode number.
MR-FREEZE <monitor> <cameo#>
This command returns the freeze function setting for
the specified cameo on the specified monitor.
NOTE: If the specified monitor is in full screen mode,
the cameo specification is redundant (i.e. unnecessary).
Parameter values for <monitor>, <cameo#> and
<boolean> are:
<monitor> 1
9
<cameo#> 1 to 16
<boolean> 0
1
EN | 30
Monitor A
Monitor B
Full Screen
Single Quad
3 x 3 Multi
4 + 3 Multi
12 + 1 Multi
4 x 4 Multi
8 + 2 Multi
Monitor A
Monitor B
Disable
Enable